Monitor Riser Stand - width and height adjustable

Height and width adjustable monitor riser stand. Print multiple middle sections (with both T-piece and T-recess) to extend the width.Height adjustable with 50mm or 100mm feet. Assembly Instructions. Apply a smear of silicone grease/lubricant to the chosen feet threads.Screw the feet into the threads of each pillar on the stand sections.Turn the sections over on a flat solid surface such as a worktop or table (feet pointing up) and align the T-pieces into the joining sections T-recess.Push down until the T clicks into the recess on the next panel.Repeat if extending the width with multiple mid-sections and complete with the opposing end section.Turn over, position on your desk/table and place the monitor.This can be printed on an A1 mini, please be aware however that this may cause some warping due to the footprint of the model taking up the entire bed - must proceed with caution. Thank you and enjoy!