Thingiverse
Monitor Stand
door winnietabz
571
Downloads
596
Likes
3
Makes
I needed a stand that would hold my monitor up instead of having to put something behind it, or on its stock stand. I designed this because i need the stand to fit perfectly in the space under a compartment and my desk, and having it on its stock stand would make it to tall.
this stand works for monitors with a height of 10 1/4" - 13 1/4" with the bolt pattern of x100.
You could use the the stud and nut that i designed or you could use a 5mm bolt diameter and nut that you can find at a hardware store.
You may also need rubber or foam with sticky backing for the leg so it wouldn't slip when standing.
Thanks for looking and the feedback.
this stand works for monitors with a height of 10 1/4" - 13 1/4" with the bolt pattern of x100.
You could use the the stud and nut that i designed or you could use a 5mm bolt diameter and nut that you can find at a hardware store.
You may also need rubber or foam with sticky backing for the leg so it wouldn't slip when standing.
Thanks for looking and the feedback.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
