Thingiverse
Monitor Stand
door Dharam
1
Downloads
2
Likes
0
Makes
I needed a simple stand for my monitor with a curved back, so I came up with this simple design. I included two holes for screws with a shaft diameter of around 4,11 mm for those wanting to secure the stands to the ground below. For my personal setup however I decided to not use screws, as I don't want to drill into my desk.
These are meant to be put on the two bottom corners of the monitor so you have to mirror the stand. The dimensions are noted in the picture above.
These are meant to be put on the two bottom corners of the monitor so you have to mirror the stand. The dimensions are noted in the picture above.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
