Monsterhunter healing potion

This is a model of the healing potion in Monsterhunter that you can use as a bottle.However, you need an empty 250ml True Fruits bottle for this, as the model is based on it. Printing instructions:I have printed it with PETG so that it can cope better with the forces during assembly.The model has tight tolerances as print it with care.The model has some small overlay areas, if you want to use additional trim remove it thoroughly. I printed with the SuperTack plate and only used small ears. Assembly In addition to the bottle, you will need a light acid such as vinegar and glue.To get the text off the bottle, leave it in vinegar for a few minutes, then you can simply wipe the text off. Then you assemble the 3D print, you can see all the steps again in the linked video. Insert the struts into the bottom, this needs some force and it clicks when they are inside.Place the bottle in the floor and slide the center ring on from above. This doesn't need any extra glue to hold it in place bu