Moose Flexi

STL/3MF Multicolor Regular eyes/ 6mm eye sockets 1 part (non moving head)/ 2 Part (Head and body) Antlered (glue them in slots)/ Non Antlered versions  Print Settings: Print in Place No Supports needed Arachne walls 2-3 walls 5-10% infill Tested down to 70%, YMMV *The heads will need to be heated up to fit over the ball on the 2 part version. Set your printer’s heat bed to 65C, lay the heads on it for a few minutes and then pop them on.   If you have adhesion issues, try a brim, glue stick or Aquanet hairspray