Thingiverse
Moss Pole
von Jorgotan
4
Downloads
23
Likes
0
Makes
A wide Moss Pole for larger plants.
If the plant outgrows it, you can just pile another pole on top of it. Make sure to add 1 or 2 bamboo sticks or some other support as it gets a bit instable after the 3rd pole part.
The stake is still WIP but should work fine as it is.
No supports needed when printing, a wide brim is definitely recommended since excess filament in some spots or warping can mess up the connection between multiple pole parts.
If the plant outgrows it, you can just pile another pole on top of it. Make sure to add 1 or 2 bamboo sticks or some other support as it gets a bit instable after the 3rd pole part.
The stake is still WIP but should work fine as it is.
No supports needed when printing, a wide brim is definitely recommended since excess filament in some spots or warping can mess up the connection between multiple pole parts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
