Motion sensor for halloween animatronics.

Description:This 3D printable enclosure is designed to hold a motion sensor (PIR or similar) for triggering Halloween animatronics.Perfect for adding a spooky surprise when someone walks by!The housing keeps your electronics protected.Print Info:Material: PLA or PETG. (Cap for adjusting whole is made of TPU.Infill: 20–30%Supports: NoEasy to assemble and wire. (See diagram at the attached picture.)👻 Bring your Halloween creations to life with motion-activated scares!Components used: HC-SR501 PIR motionsensor Sharp PC817 Optocoupler Battery 9V Clip Connector Type T Square Rocker Switch 2Pin Black On-Off KCD1100 ohm resistor1 x 9 volt battery