motor

this electric motor does not need supports and can be printed at fast speedsMaterials:1m6 bolts6-m5 boltsApprox % pound 18mag Copper wire [0.9mm]3D PLA printed CAD design stator (File available online]3D PLA printed CAD design rotor (File available online]15 cm Insulated copper wire70-12x2mm neodymium magnets (Available on Amazon]1-brushless electronic speed controller (Available on amazon]12x5mm BarringReclaimed RC car batteryReclaimed laptop chargerOne male and female electrical 5.5x2.1 mm pigtail jack connectorSoldierElectrical tapeWood base(Optional〕CuacMotor Assembly InstructionsStep 1:Wrap wire around each of the 6 m5 bolts 45 times leaving 4-6inches of spare wire on both ends. Using a drill can be helpful.Step 2: Screw bolts into the statorStep 3: Solder wires together in a Y configuration (as pictured)Step 4: Install the barring into the rotor and install 6 magnets per slot (3 inslot, 2 under, and 1 on top) in the rotor in an alternating polarity pattern.Note:the 2 magnets on t