Motorized Platform Jack

This is a remix of the "Platform Jack" to make it completely motorized. This is a fairly simple and cheap project with little prior knowledge of electronics needed.

Video: https://youtube.com/shorts/DoBgDl5bbw8

You will need:

AA battery housing(2x)
Standard Carling Switch
Small DC motor(I used the 50RPM which takes it about 30 seconds to fully extend and in my opinion it is a little slow. The higher RPM motors should fit this as well) https://www.amazon.com/gp/product/B082GNPTCS/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&th=1
20g wire

Assembly:

-Put the switch in the 'CONTROLS' Box and the motor in the 'motor mount' before you start connecting wires
-On the switch, connect terminals 1 and 6 to one terminal of the motor and 3 and 4 to the other.
Switch Diagram:
1 4
2 5
3 6
-Connect your batteries together in series and then to terminals 2 and 5
-Make sure to test the switch to make sure your motor is turning in the right directions.
-Use a Dremel to make