Thingiverse
Mountable PCB Prototype Board Box
por skellep193
32
Descargas
20
Likes
0
Makes
A mountable PCB box that fits a 20mm x 80mm board. The box mounts well to a 20mm aluminum extrusion. I used this for a ABL rig on a Creality CR-10.
It as openings on thew top and bottom as well as ports for running wires on either side. Nothing fancy, but functional.
If you print the top you may need supports.
UPDATES:
PCBBox_80_20_Lid_v2.stl added on 21Feb2018. Alternate lid has a gap that allows wires that are already connected to be run into the ports located at each end.
It as openings on thew top and bottom as well as ports for running wires on either side. Nothing fancy, but functional.
If you print the top you may need supports.
UPDATES:
PCBBox_80_20_Lid_v2.stl added on 21Feb2018. Alternate lid has a gap that allows wires that are already connected to be run into the ports located at each end.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
