Thingiverse
Mounting Bracket
von AT3chnicality
1
Downloads
1
Likes
0
Makes
My mom's plate separated from it's old bracket so I threw this together as the epoxy was drying on the plate (cuz it broke from the fall). I then epoxied this bracket to the back.
There's enough room in the cutout of the bracket to hang from a sheetrock screw, or for a small hook that you can get for hanging photos.
It is 6mm thick
25mm tall
20mm wide
the gap/opening is about ~2.7mm~
There's enough room in the cutout of the bracket to hang from a sheetrock screw, or for a small hook that you can get for hanging photos.
It is 6mm thick
25mm tall
20mm wide
the gap/opening is about ~2.7mm~
AT3chnicality veröffentlicht auch auf
30 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
