Thingiverse
Gadgets
Zum Modell
Mouse bungee
266
Downloads
275
Likes
5
Makes
I made this mouse bungee because i wanted a bungee that does not need tape or weight.
You just place it slightly under the mouse pad.
Printed in pla, all you need is a small m1.5 skrew(or similar, hole is 1.5 mm) you can also just glue the parts together.
Been using this for 4 monthes and couldn't be happier about the design.
You just place it slightly under the mouse pad.
Printed in pla, all you need is a small m1.5 skrew(or similar, hole is 1.5 mm) you can also just glue the parts together.
Been using this for 4 monthes and couldn't be happier about the design.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
