Thingiverse
MOUSE FIGURE
von catf
78
Downloads
88
Likes
0
Makes
I present to you different mouse figurines for decorated your interior, ideal for a child room 8 in all
All figures are small sizes 4 cm long 2 to 3 cm wide and 1.6 mm deep
The support has been printed in PLA, and painted with acrylic paint then I varnished them with an aerosol all supports fast drying (inside / outside) for a better holding of the paint
50% Sufficient filling rate if painted thereafter
70% print speed not too fast for better rendering
215 ° PLA printing temperature
60 ° shelf temperature
0.2 layer thickness
0.8 hull thickness
NO SUPPORT
PRINTING TIME 37 MIN
All figures are small sizes 4 cm long 2 to 3 cm wide and 1.6 mm deep
The support has been printed in PLA, and painted with acrylic paint then I varnished them with an aerosol all supports fast drying (inside / outside) for a better holding of the paint
50% Sufficient filling rate if painted thereafter
70% print speed not too fast for better rendering
215 ° PLA printing temperature
60 ° shelf temperature
0.2 layer thickness
0.8 hull thickness
NO SUPPORT
PRINTING TIME 37 MIN
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!