Thingiverse
Mouse Pad
door MeisterWerks
4
Downloads
3
Likes
0
Makes
• Print with TPU filament
• Print face down on a textured build plate.
• Scale this up or down proportionally with X & Y to make any size you want. Leave the z axis at 3mm.
• Current file size is 8" x10" / 203mm x 254mm.
• Photos of my mouse pad were at 8.25"x7" due to my build plate size.
(I'm planning on printing a larger one on my Kobra Max soon)
Also, if you use clear TPU, you can print out any logo or photo you would like and place it under the pad. I didn't even need to glue it, but I suppose you could use some contact cement or spray adhesive if you wanted to make it permanent. You could also print 2 at 1.5mm height by changing the Z perportions and sandwich it in between the two prints.
Enjoy!
• Print face down on a textured build plate.
• Scale this up or down proportionally with X & Y to make any size you want. Leave the z axis at 3mm.
• Current file size is 8" x10" / 203mm x 254mm.
• Photos of my mouse pad were at 8.25"x7" due to my build plate size.
(I'm planning on printing a larger one on my Kobra Max soon)
Also, if you use clear TPU, you can print out any logo or photo you would like and place it under the pad. I didn't even need to glue it, but I suppose you could use some contact cement or spray adhesive if you wanted to make it permanent. You could also print 2 at 1.5mm height by changing the Z perportions and sandwich it in between the two prints.
Enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
