Thingiverse
MPCNC gantry style conversion
von Fab_ster
39
Downloads
36
Likes
0
Makes
This is a conversion kit for the mpcnc to change it to a classic gantry style cnc.
You can use all parts of the mpcnc.
!!! Attention only for the 25mm version!!!
For the two cross tubes you need two M5 threaded rods to pull the two side plates together.
The side rollers must be printed two times but mirrored once. These are then glued together with epoxy glue. There are holes to help with positioning.
If you have any questions please pm me or leave a comment. I try as best as I can to help.
You can use all parts of the mpcnc.
!!! Attention only for the 25mm version!!!
For the two cross tubes you need two M5 threaded rods to pull the two side plates together.
The side rollers must be printed two times but mirrored once. These are then glued together with epoxy glue. There are holes to help with positioning.
If you have any questions please pm me or leave a comment. I try as best as I can to help.
Fab_ster veröffentlicht auch auf
27 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
