MPCNC Parallel Conduit Chain Support

These are 3/4" EMT MPCNC Conduit adapters I created. They enable me to run parallel pipes to my X and Y axis, which I am experimenting with holding cable chains to keep all wires and chains above the workable area.

This provides a cleaner look and helps maintain a cleaner work surface.

Ideally, for maximum conduit support, you will print 4 double corners, cut a new set of x and y conduit pipes, then assemble. The problem with running only one x and y is that one of the corners will have to use the 'C' end and it has to fit tight, or the pipe on that side will sag. Take a look at the pictures to get an idea.

Comments and suggestions welcome.

Happy tinkering.