Thingiverse
MPCNC Vacuum Mount
von Lucidwolf
11
Downloads
5
Likes
0
Makes
Since it worked so well as a prototype I thought i would upload prior to final.
I think I am going to add a 45 deg fitting to the swivel, I have to wait for the brush material as well before i finish the boot and upload the full FreeCAD files.
FINAL:
With a frangible cardboard tube it cleans up well enough without a boot and i dont have to worry about crashing it because it bends out of the way so I am calling it good enough with just the tube.
I think I am going to add a 45 deg fitting to the swivel, I have to wait for the brush material as well before i finish the boot and upload the full FreeCAD files.
FINAL:
With a frangible cardboard tube it cleans up well enough without a boot and i dont have to worry about crashing it because it bends out of the way so I am calling it good enough with just the tube.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
