Thingiverse
MPCNC Wire Support
von rullmann
62
Downloads
22
Likes
0
Makes
These brackets allow for mounting a 1" aluminum angle support along the X axis to a MPCNC.
These offset the angle slightly rearward to clear the Z axis and are ~40mm in height above the stepper bracket mounting holes in order to clear the middle gantry.
Print one of each bracket out and mount them to the stepper brackets by swapping out the screws for a ~5mm longer version.
These offset the angle slightly rearward to clear the Z axis and are ~40mm in height above the stepper bracket mounting holes in order to clear the middle gantry.
Print one of each bracket out and mount them to the stepper brackets by swapping out the screws for a ~5mm longer version.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!