MPMD Mask Ear Saver

Updates:
23/04/2020
Uploaded a variation of the design. Again, since I have nothing to test with, this is basically just a trial piece. I tried to allow for various head sizes, mask positioning and strap sizes with this design and still allow it to fit the bed of a MPMD be relatively quick to print and be stackable.
Try it out and let me know if there are any issues.

This model is designed a little lighter so strength may be an issue. I tried to keep the print time close to 15-20 minutes per piece. This will also fit the MPMD bed without an issue and can be stacked. I also tried printing at 0.28 layer height which appears to work fine and speeds up the printing a bit. Adjusting the line width to 0.5 also appear to speed up the print somewhat without affecting print quality much.

I am still trying to find the best way to get the stacked prints to come out with the best quality. So far layer height at 0.28 and line width 0.5 with no gap between prints provides a relatively good