MPSM Bed Leveling Utility

This is a quick Gcode script for bed leveling on the Monoprice Select Mini. It finds home then steps through 5 positions, waiting for 5(or 2) seconds at each spot to test the clearance. The position it steps through are: Front Left (5,5), Back Left (5,115), Back Right (115,115), Front Right (115,5), and Center (60,60).

There are two versions:
Utility_Bed_Leveling.gcode (5s pause and 80mm/s movement)
Utility_Bed_Leveling_Quick_2s.gcode (2s pause and 100mm/s movement)

To use this script, first make sure there's no filament on the outside of your nozzle. Then put a piece of A4 paper on the build plate. Run the print, and at each of the 5 locations test the fit by trying to slide the paper around. Then after all 5 positions have been done, adjust the four corners. Then run it again and repeat until you're happy with the fit.

I like to adjust the fit so that there is definitely some resistance when moving the paper around but not so much that it leaves an obvious mark/gouge on