Thingiverse
MSOE Coaster
von benbrochtrup
2
Downloads
2
Likes
0
Makes
This is a 3.5" drink coaster with a slight ridge on the outer edge. It has a MSOE logo cutout in the middle. For this print I did a filament swap after layer 10 to make the multicolored effect. The STL is in inches format so you may need to adjust some settings in your slicer to accommodate it. Feel free to check out the rest of my college coaster collection.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
