Thingiverse
MT07 Dash Relocation
by OzzyMozzy
27
Downloads
18
Likes
0
Makes
This is to suit the MT-07 2018 - 2020 model. It may fit the earlier ones! I just don't have one to test it with.....
You will need the wedge style washers as the wholes on the bike aren't flat.
It is what I consider a bit rough, I'm not experienced enough to use fancy software like Fusion. But it works!
For the Lid that covers it all up, you will need to line it up and drill the holes for the self tapping screws. Be careful as there isn't much for them to bite into.
You will need the wedge style washers as the wholes on the bike aren't flat.
It is what I consider a bit rough, I'm not experienced enough to use fancy software like Fusion. But it works!
For the Lid that covers it all up, you will need to line it up and drill the holes for the self tapping screws. Be careful as there isn't much for them to bite into.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!