Thingiverse
Multi Use Stand
door cfeniak
60
Downloads
48
Likes
0
Makes
A height, angle, and position adjustable stand. Can hold a book, magazine, tablet, drink, or small plate. Extrusion used is 2020 V-Slot. I printed this in PETG.
Needed:
1.6 meters of 2020 V-Slot extrusion
4x 625ZZ bearings
14x M5 T-nuts
14x M5x10mm cap head bolts
2x M5x50mm cap head bolts (for pivoting joints)
2x M5x40mm cap head bolt (for vertical clamp and toothed pivot)
3-5x M5 washers
2 M5 nuts (standard)
2 Printed Nut Holders:
http://www.thingiverse.com/thing:641854
OR
http://www.thingiverse.com/thing:1177235
To build:
1) Print off all parts then clean up any brim or bridged sections. Clean printed holes with a drill if desired
2) Epoxy the two plate pieces together
3) Cut 2020 extrusion. I used to 50cm pieces for the vertical section and two 25-30cm pieces for the base.
4) Assemble the base with 10 M5x10mm bolts and T-nuts
5) Tap the top of the upper vertical piece to an M5 thread or drill it to 4.5mm and force the M5 bolt to cut it's own threads (us
Needed:
1.6 meters of 2020 V-Slot extrusion
4x 625ZZ bearings
14x M5 T-nuts
14x M5x10mm cap head bolts
2x M5x50mm cap head bolts (for pivoting joints)
2x M5x40mm cap head bolt (for vertical clamp and toothed pivot)
3-5x M5 washers
2 M5 nuts (standard)
2 Printed Nut Holders:
http://www.thingiverse.com/thing:641854
OR
http://www.thingiverse.com/thing:1177235
To build:
1) Print off all parts then clean up any brim or bridged sections. Clean printed holes with a drill if desired
2) Epoxy the two plate pieces together
3) Cut 2020 extrusion. I used to 50cm pieces for the vertical section and two 25-30cm pieces for the base.
4) Assemble the base with 10 M5x10mm bolts and T-nuts
5) Tap the top of the upper vertical piece to an M5 thread or drill it to 4.5mm and force the M5 bolt to cut it's own threads (us
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
