Multi Use Stand

A height, angle, and position adjustable stand. Can hold a book, magazine, tablet, drink, or small plate. Extrusion used is 2020 V-Slot. I printed this in PETG.

Needed:
1.6 meters of 2020 V-Slot extrusion
4x 625ZZ bearings
14x M5 T-nuts
14x M5x10mm cap head bolts
2x M5x50mm cap head bolts (for pivoting joints)
2x M5x40mm cap head bolt (for vertical clamp and toothed pivot)
3-5x M5 washers
2 M5 nuts (standard)

2 Printed Nut Holders:
http://www.thingiverse.com/thing:641854
OR
http://www.thingiverse.com/thing:1177235

To build:
1) Print off all parts then clean up any brim or bridged sections. Clean printed holes with a drill if desired
2) Epoxy the two plate pieces together
3) Cut 2020 extrusion. I used to 50cm pieces for the vertical section and two 25-30cm pieces for the base.
4) Assemble the base with 10 M5x10mm bolts and T-nuts
5) Tap the top of the upper vertical piece to an M5 thread or drill it to 4.5mm and force the M5 bolt to cut it's own threads (us