Multiboard Fantom Wallet Wall Holder

Keep your Fantom wallet secure, stylish, and out of your pocket — literally on display like the prized gadget it is. Designed for the Multiboard wall system, this 3D‑printable holder snaps into your multiboard grid using two push‑fit connectors so so requires two snaps. It fits both thin and medium Fantom wallet sizes, and yes—it supports wallets with or without the money clip. Other variants? Print at your own risk. This thing is optimally snug—but if you tweak the wallet size or clip setup, consider it “unsupported experimental territory.”Why you’ll love it:Secure but rebellious: Fantom wallet stays put until you decide to take it back.No screws needed: Just pop into your Multiboard grid and you’re good—no hardware, no tears.Minimalist aesthetic: Keeps your EDC clean, practical, and visible—right where you expect it.Print & Install NotesOnly tested on Fantom thin and medium wallets. Others may slip or jam—enter at your own risk.