Multiboard Wireless Charging Dock

Phone dock designed for multiboard using the raised multiconnect snap system. I made it for the Livboj charger from IKEA and it fits snugly for me. The charger cutout is 91 × 91 mm, with a 12 × 8.7 × 3.2 mm hole for the wire in the bottom middle. The charger is slightly raised for better alignment with the phone’s wireless charging spot. The phone space is roomy enough for a case— up to 93 mm wide and 14 mm deep—with slightly curved corners at the bottom to prevent dirt buildup. There’s also a hole on the resting shelf for direct charging. This is my first design, made in Tinkercad, with the snap-in back from the Multiconnect files added. You can use up to six raised Multiconnects, but I only use two and it works fine. The pictures show the draft print (Sport mode, 0 % infill, tall layers), which isn’t very polished but sturdy enough for testing. The final print profile will look much nicer! I’d love to see your prints if you try it.