Thingiverse
Multitool Wall Mount
door ranikins
2
Downloads
2
Likes
0
Makes
A wall mount for whatever multitool I have. Made for a multitiil measuring 10.5 cm tall, 2cm deep and 5cm wide at the top, 4cm wide at the bottom.
The back plate is sheer flat for sticking to the wall with guerilla mounting tape.
In order to print it with the back plate on the printer bed, your printer needs to be tuned to bridge infill without substantial sagging, though you could just try changing orientation.
The design on the face was done by pausing the printer at the layer the design starts and changing the filament.
The back plate is sheer flat for sticking to the wall with guerilla mounting tape.
In order to print it with the back plate on the printer bed, your printer needs to be tuned to bridge infill without substantial sagging, though you could just try changing orientation.
The design on the face was done by pausing the printer at the layer the design starts and changing the filament.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
