Thingiverse
MX Stabilizer Tester
von derpturtle
6
Downloads
1
Likes
0
Makes
Stabilizer tester featuring some of the most widely available stabilizer sizes. All dimensions are taken straight from the official Cherry MX datasheet, with a 0.005-inch offset applied to account for 3d printing tolerances.
Screw-in stabs only. This was tested with genuine Cherry stabilizers as well as v1 and v2 Durock stabilizers.
Screw-in stabs only. This was tested with genuine Cherry stabilizers as well as v1 and v2 Durock stabilizers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
