Thingiverse
MX Switch Fidget Cube
von TimeWaster
12
Downloads
8
Likes
0
Makes
A fidget cube toy that accepts standard MX type switches (Cherry, Kailh, Gateron, etc.).
It feels very good in your hand especially when the print was sanded down a bit.
The .stl file is meant to be printed twice and then glued together with 4 pegs made from Cotton Bud rods, cut down to a maximum length of 10mm (depening on your print quality you may need to drill out the holes a bit).
Please note that the .stl file is made for Cotton Bud rods which are 2.6 mm in diameter, please check what diameter your Cotton Bud rods have before printing it. If you need a different diameter open the .scad file in OpenSCAD and change the parameter accordingly.
It feels very good in your hand especially when the print was sanded down a bit.
The .stl file is meant to be printed twice and then glued together with 4 pegs made from Cotton Bud rods, cut down to a maximum length of 10mm (depening on your print quality you may need to drill out the holes a bit).
Please note that the .stl file is made for Cotton Bud rods which are 2.6 mm in diameter, please check what diameter your Cotton Bud rods have before printing it. If you need a different diameter open the .scad file in OpenSCAD and change the parameter accordingly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
