MyGeiger 2 Case

a simple case for the MyGeiger Geiger counter from www.rhelectronics.com. the photos show my version before i did some changes to the design, the new design should look nicer and the power switch hole was a little misaligned.

you'll need to trim the header for the display down about a mm and you'll need 2 15mm male-female spacers (use nylon as they are close to the HV section on the board)

the hole in the middle of the top radiation symbol is for a LED bezel to extend the count LED to the front panel (bezel is installed in the photos but no LED in the bezel)

the 3 extra holes in the bottom of the lid are for a handle that i havent designed or decided if i want yet..