Thingiverse
Nanode Case
door asc
7
Downloads
8
Likes
0
Makes
2mm acrylic case cut on a laser cutter for a Nanode (http://www.nanode.eu/ and http://www.thingiverse.com/thing:7463).
Designed to be small, light and able to have a removable lid.
There are two models, one that is simply a case the other has a base that include mounts which allow the Nanode and case you be attached to a wall.
The design allows all the parts to be cut on an A4 size sheet of 2mm acrylic.
The height of the case allows for headers to be used and supported by the case, meaning shields can be used nicely.
The design works well with 3mm thick material too but you need to move the tabs out by 1mm to make it all fit nicely. If you don't feel like moving the tabs out it still works well however.
Equipment needed:
1 x A4 2mm thick acrlic/perspex
2 x M3 12mm Screws or M3 12mm Socket Cap Screws
2 x M3 Nuts
3 x M2 10mm Screws
12 x M2 Nuts
4 x 6mm rubber feet (optional)
and a small amount of Super Glue
Designed to be small, light and able to have a removable lid.
There are two models, one that is simply a case the other has a base that include mounts which allow the Nanode and case you be attached to a wall.
The design allows all the parts to be cut on an A4 size sheet of 2mm acrylic.
The height of the case allows for headers to be used and supported by the case, meaning shields can be used nicely.
The design works well with 3mm thick material too but you need to move the tabs out by 1mm to make it all fit nicely. If you don't feel like moving the tabs out it still works well however.
Equipment needed:
1 x A4 2mm thick acrlic/perspex
2 x M3 12mm Screws or M3 12mm Socket Cap Screws
2 x M3 Nuts
3 x M2 10mm Screws
12 x M2 Nuts
4 x 6mm rubber feet (optional)
and a small amount of Super Glue
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
