Thingiverse
Napkin holder
von asmanovlev
3
Downloads
6
Likes
0
Makes
WARNING! THIS WIP; FINAL VERSION HERE: https://www.thingiverse.com/thing:5437413
On photo you see pre-fixed model. You see it's for a bit askew because during printing printing plate unstuck from magnetic plate.
I made some changes (increased radius of stand connection, increased height of stand rod and increased length between stand rod and fulcrums)
PS: thing is work-in-progress because i haven't tested my changes. But theoretically everything should be fine.
UPD: Final version here: https://www.thingiverse.com/thing:5437413
On photo you see pre-fixed model. You see it's for a bit askew because during printing printing plate unstuck from magnetic plate.
I made some changes (increased radius of stand connection, increased height of stand rod and increased length between stand rod and fulcrums)
PS: thing is work-in-progress because i haven't tested my changes. But theoretically everything should be fine.
UPD: Final version here: https://www.thingiverse.com/thing:5437413
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
