Thingiverse
Nautilus Shell
von tc_fea
303
Downloads
308
Likes
15
Makes
This is a nautilus shell split in half.
I have included two .stl's, one is 1 mm thick walls and the other is 1.5 mm thick walls.
I liked the 1 mm thick version but it did not print well on my cupcake with an MK5, maybe those with newer printers can print it cleanly.
The 1.5 mm thick version is shown in the top photo & last photo and printed much better on my setup.
I have included two .stl's, one is 1 mm thick walls and the other is 1.5 mm thick walls.
I liked the 1 mm thick version but it did not print well on my cupcake with an MK5, maybe those with newer printers can print it cleanly.
The 1.5 mm thick version is shown in the top photo & last photo and printed much better on my setup.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!