Thingiverse
NavX mount
von domyg27
3
Downloads
0
Likes
0
Makes
Took inspiration from this calibration jig
https://www.printables.com/en/model/373417-navx2-mxp-calibration-jig
This holder is used to mount your NavX off your Rio
Features 4 #10 mounting holes with clearance for a Rev MXP extension cable, as well as two screw holes to mount the NavX in
Uses existing screws from the NavX which are #4-40 1/4
You could upgrade them to #4-40 1/2 if you wanted more bite on the screws or if you wanted to combine this with https://www.thingiverse.com/thing:1340682 to have a full enclosure.
Fits NavX classic and NavX2
https://www.printables.com/en/model/373417-navx2-mxp-calibration-jig
This holder is used to mount your NavX off your Rio
Features 4 #10 mounting holes with clearance for a Rev MXP extension cable, as well as two screw holes to mount the NavX in
Uses existing screws from the NavX which are #4-40 1/4
You could upgrade them to #4-40 1/2 if you wanted more bite on the screws or if you wanted to combine this with https://www.thingiverse.com/thing:1340682 to have a full enclosure.
Fits NavX classic and NavX2
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
