Thingiverse
Naze32 Case
von LasagnePrints
11
Downloads
8
Likes
0
Makes
This is a case for the Naze32.
I decided to make this so as to prevent my Naze from incurring any damage when crashing. Despite there being other designs I needed something that would protect it from every angle.
I printed this with a layer height of 0.2mm and a fill of 10%. Depending on what RC gear you use some trimming of this print may be required.
I decided to make this so as to prevent my Naze from incurring any damage when crashing. Despite there being other designs I needed something that would protect it from every angle.
I printed this with a layer height of 0.2mm and a fill of 10%. Depending on what RC gear you use some trimming of this print may be required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
