Thingiverse
Needle Puller
door 5490robert
61
Downloads
32
Likes
1
Makes
This is a simple needle puller, used to effectively remove the needle, or pointer, from gauge's and clock's, without damage.
I have used a Cap Screw Head M5 25mm, for the bolt to push down on the pivot or pointer shaft of the gauge, A fine tip is needed at the end of your bolt, around 1 - 1.4mm should be ok.
If you have a M5 thread tap you can use this to start a thread in the body of your puller.
If you like you can print a fancy handle for the cap, its a very snug fit, just turn a little as you push it together.
I have used a Cap Screw Head M5 25mm, for the bolt to push down on the pivot or pointer shaft of the gauge, A fine tip is needed at the end of your bolt, around 1 - 1.4mm should be ok.
If you have a M5 thread tap you can use this to start a thread in the body of your puller.
If you like you can print a fancy handle for the cap, its a very snug fit, just turn a little as you push it together.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
