Thingiverse
Negative tolerance test
door StafDehat
15
Downloads
9
Likes
1
Makes
Once printed, push out as many pegs as you can. The numbers on the sides indicate the gap width between the triangular case and each peg, in millimeters.
On my own print, I was able to remove the 0.20mm and up, but the 0.15 and lower were stuck fast. I think that's pretty standard. If you can get better, I'd be curious to know what printer you're using.
On my own print, I was able to remove the 0.20mm and up, but the 0.15 and lower were stuck fast. I think that's pretty standard. If you can get better, I'd be curious to know what printer you're using.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
