Nerf Kronomag conversion

Different models for Talon vs Katana and 16mm barrel vs 17/32 brass
"Both" model is for both talon and katana

For the 3D printed pusher you will need a 012 O ring (common pusher O ring)

You will need an M3x20 or M3x25 screw for the mag release pivot.

For the brass barrel and pusher you will need a length of 17/32 brass (I used 10 inches but) and 90mm of 1/2 in brass for the pusher. For the pusher, cut 12 small lines in the end (about 5mm) and gently roll the end over to create a taper to push the darts. I also glued my barrel into the front of the adapter with some epoxy.

For the ram base I put a single wrap of electrical tape around the outside to get a good air seal into the plunger tube and make sure it wouldn't come out.

The cutting template is the same for both the talon or katana adapter. Center on the blaster and trace the inside. In most places there is about 2mm worth of margin.

If you have any questions feel free to comment and ask.

For the mag