Nerf Longshot Barrel Cover

Hi o/

After rebuilding our recently scavenged N Strike Longshot, I realised how much I hated that hole thingo in the top of the barrel blaster section. Apparently it's there to hold a dart... a dart!

So here is a cover bit to snap into that hole and make it look less like someone forgot to finish the design and more like someone, well, did.

My printer pooped the last tiny bit at the top of the pipe section, but it wasn't enough to worry about so I fitted and photographed it anyway.

Printed on a Voxelab Aquila, eSun gold PLA+ filament.
25% infill, raft, about 1.5 hours print time.

You can undo the top 6 screws of the blaster and gently pry the halves apart by half a centimeter or so. That will give you enough room to snap the printed cover in place.

Enjoy.