Nerf Longshot Bolt Base Cup

This is a sealed boltbase or boltcup for the nerf longshot. These somewhat precise parts may or may not work based on your printer's tolerances, accuracy, etc etc.

All versions accept 19/32" brass for the insert, which slides directly over the 9/16" in a standard sleeper breech. They also can use grub screws to swap out boltbases and do maintenance on the tube - just drill through the hole on the part.

The "OPEN" files are for lipless plunger tubes – I've only tested these with modified stock plunger tubes but theoretically should work with Alpha Kit tubes too. They also use 2 o-rings instead of one for better seal.

The "CLOSED" files are for tubes with lips - e.g. stock, artifact, OMW. I have not tested this with the new Worker tube but imagine that it should work just fine. They also can use the small-ring on a stock boltbase for sealing too.

The "stock/artifact" designations are for stock LS and artifact o-rings. I have not tested these with Worker/OMW o-rings.

T