Nerf Rival Dueling Tree

Update 10/7/20: Printed and set up 4 paddles. They do seem to bounce off the opposite side when hit and return back to the original side. lol. I did add a small piece of open cell foam inside the lower swivel in between the bearings to add just a bit of friction. Which helps. But I think Increasing the tilt of the mount on the base will help also so the paddles need more force to bounce back, and this will also help the paddles come to a rest all the way forward. I added the Base 10deg file as an alternate. The original was only tilted 5 degrees.

Update 10/5/20: Found one mistake with the L stem. Updated the file. The small step wasn't deep enough on the small 45 section to allow for proper assembly of the following stem.

This is a dueling tree for the Nerf Rival series of blasters. It may work with others depending on the velocity of the projectiles. It was made modular so you can print and stack as many paddles as you want but should be done in sets of 2 with a minimum of 4 to