Thingiverse
Nerf Suppressor
door Kodus_Cowboy
3
Downloads
2
Likes
0
Makes
This Nerf Suppressor has been remixed to fix a design flaw that prevented it from fitting onto the barrel. I first printed this from the original, and "edited" the finished product using a Dremel and it was quite a pain.
NOTE: This design has not been tested. I'm 99% sure it will work fine, but I have not printed this edited design.
Printing: (no supports needed)
settings used: (it will work with any, but here's what I used) layer height: 0.28 mm, infil: 20%, wall thickness: 3 layers
NOTE: This design has not been tested. I'm 99% sure it will work fine, but I have not printed this edited design.
Printing: (no supports needed)
settings used: (it will work with any, but here's what I used) layer height: 0.28 mm, infil: 20%, wall thickness: 3 layers
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
