Thingiverse
NES Controller Botom - Blank
von LeatherWing
33
Downloads
27
Likes
0
Makes
Another NES controller, this time in Openscad.
I'm creating my own RetroPi NES controller with a Pi Zero. My hope is to find a way to keep all connections internal and run HDMI and power out the original hole. Unfortunately I haven't found an HDMI cable with a low enough profile to allow that to happen.
I'll probably end up just cutting holes for external connections, but until then here's a blank bottom for you to customize to your own liking.
This is a copy of the bottom of [this controller I bought from Amazon](
https://www.amazon.com/gp/product/B01N5HEQC2/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1).
If you make something with it (or know where some ultra low profile, right angle, mini hdmi cables can be found) Let me see it!
I'm creating my own RetroPi NES controller with a Pi Zero. My hope is to find a way to keep all connections internal and run HDMI and power out the original hole. Unfortunately I haven't found an HDMI cable with a low enough profile to allow that to happen.
I'll probably end up just cutting holes for external connections, but until then here's a blank bottom for you to customize to your own liking.
This is a copy of the bottom of [this controller I bought from Amazon](
https://www.amazon.com/gp/product/B01N5HEQC2/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1).
If you make something with it (or know where some ultra low profile, right angle, mini hdmi cables can be found) Let me see it!
LeatherWing veröffentlicht auch auf
3 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
