Netatmo Sunshield

Remix from https://www.printables.com/model/607388-netatmo-sunshield DescriptionThe Netatmo outdoor module is supposed to be placed in a shady place with sufficient air flow for accurate readings. Ideally, it is placed high above the ground and not too close to buildings.However, it's not always easy to find a spot where the sun is not shining at least at some times of the day. So we need to make our own shade, taking care that we don't block the air flow/convection.This sun shield has an outer diameter of about 13cm, leaving around 2,5cm distance to the Netatmo module in order to avoid heat transmission. The shield provides a central hole for a M6 screw at the bottom ring. PrintingYou will need:1x Bottom (no support needed)3x Pillar (no support needed, print laying flat on its side)5x Segment (no support needed, print upright)1x TopRing (no support needed, use 100% infill and high temperature while printing so that it doesn't break when inserting/removing the roof)1x Roof