Thingiverse
NETGEAR switch stack holder
von timtamshortage
21
Downloads
13
Likes
0
Makes
A stacker for holding two NETGEAR116v2 switches to the wall in our network closet. Screw holes to hold it to the wall.
(we already had one switch mounted, but then upgraded to a second, so we just hold our second switch on with the bracket, but it can hold your switches to the wall)
has small holes on the top to see the lights flashing on the switches to allow you to make sure they are operating.
Let me know if you have ideas to change them up!
(we already had one switch mounted, but then upgraded to a second, so we just hold our second switch on with the bracket, but it can hold your switches to the wall)
has small holes on the top to see the lights flashing on the switches to allow you to make sure they are operating.
Let me know if you have ideas to change them up!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
