NEW GUITAR WALL MOUNT

by DT3D_PRINT · Music

205 Downloads

59 Likes

48 Makes

Guitar or Bass Guitar Wall mount IDEALLY FOR SYMMETRIC GUITAR HEADS (Fender strats etc will fit but you may get a slight tilt due to the headstock geometry not being symmetrical)hidden Screw Design. Fix bracket to wall then slot mount over43mm and below necks - MUST print bracket laying down so layer grain runs the length or bracketMUST print the mount standing up. If not, I can not guarantee the strength of the part. 0.2 layer heightMinimum of 3 wall thickness30% triangular infillThe guitar mount works great in quality PLA, but stronger materials would be beneficial. See the image attached for hole dimensions. I used M4 Screw. Approx 40mm in lengthUse suitable wall fixings to avoid failure.