Thingiverse
Music
Vai al Modello
NiftyCase Sidecar
2
Download
4
Likes
0
Makes
I had the need for an extension for my NiftyCase because I missed some HP for the DSP module and that little design emerged some interest on reddit so I decided to make it available here.
It is printed in 3 Parts:
The box that conains the module and two clamps that are press fitted onto the box.
In addition two ruthex thread inlays are required to tighten the module. Everything is printable without supports.
In the previewimage the clamps are bowing out because the gaps where to close. I adjusted them in the final file to a gap of 0.25mm. That should be enough to press the mounting brackets onto the modulebox easily.
Marked as work in progress because It has been done in around 30min and maybe I'll improve it in the future.
It is printed in 3 Parts:
The box that conains the module and two clamps that are press fitted onto the box.
In addition two ruthex thread inlays are required to tighten the module. Everything is printable without supports.
In the previewimage the clamps are bowing out because the gaps where to close. I adjusted them in the final file to a gap of 0.25mm. That should be enough to press the mounting brackets onto the modulebox easily.
Marked as work in progress because It has been done in around 30min and maybe I'll improve it in the future.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
