Thingiverse
Nikon Eclipse Ti2 Light Shield
von wavexx
2
Downloads
1
Likes
0
Makes
*Light shield* designed explicitly to fit a Nikon Eclipse Ti2, attaching directly to the lens barrel.
Contrarily to the original "light shield", this accessory blocks light coming from *all* sides, allowing operation in a fully lit environment. Can be left permanently attached, and even when installed at the lowest possible position doesn't significantly reduce the moving plate's range of motion.
**Materials**
* M6 tap
* PET is **recommended** for the collars (inner and outer rings).
* A strongly black material should be used for the shade.
**Printing**
Print all parts with a 0.4 nozzle and 0.2 layer height (or lower).
**Assembly**
Use the M6 tap to thread the hole on the outer collar. Insert the screw and ensure it can move smoothly troughout the entire thread. Align the tip of the screw to the inner side of the collar.
![](https://thingiverse-production-new.s3.amaz
Contrarily to the original "light shield", this accessory blocks light coming from *all* sides, allowing operation in a fully lit environment. Can be left permanently attached, and even when installed at the lowest possible position doesn't significantly reduce the moving plate's range of motion.
**Materials**
* M6 tap
* PET is **recommended** for the collars (inner and outer rings).
* A strongly black material should be used for the shade.
**Printing**
Print all parts with a 0.4 nozzle and 0.2 layer height (or lower).
**Assembly**
Use the M6 tap to thread the hole on the outer collar. Insert the screw and ensure it can move smoothly troughout the entire thread. Align the tip of the screw to the inner side of the collar.
