Thingiverse
NIL
door elton_wkh
1
Downloads
1
Likes
0
Makes
This is a gaming accessory.
Material needed:
Aluminium Foil
Double side adhesive tape (thick)
the length between two plates are good fit to ipad 2018 with plastic case. thickness of both my ipad and case is approximately 1cm. If you are going to put it into other device, remember to regulate the distance between two main plate.
ps. Adhesive tap should not sticking too tight in order to pretend your little fingers! ;)
increase the thickness of tape may also help to adjust the distance conveniently.
https://youtu.be/O571OFePSAo
You are welcome to subscribe my youtube channel~~
Material needed:
Aluminium Foil
Double side adhesive tape (thick)
the length between two plates are good fit to ipad 2018 with plastic case. thickness of both my ipad and case is approximately 1cm. If you are going to put it into other device, remember to regulate the distance between two main plate.
ps. Adhesive tap should not sticking too tight in order to pretend your little fingers! ;)
increase the thickness of tape may also help to adjust the distance conveniently.
https://youtu.be/O571OFePSAo
You are welcome to subscribe my youtube channel~~
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!