Thingiverse
Nilight, Switch Case
von PSomeone
7
Downloads
6
Likes
0
Makes
Nilight, Switch Case
Designed for #6 screws and nuts (Nuts are press in so they fit super tight but keeps them from falling out when your messing with it)
If you need a mount hole pattern PM me, this was done for a friend and they were not sure of the hole pattern so there isn't one.
Designed for #6 screws and nuts (Nuts are press in so they fit super tight but keeps them from falling out when your messing with it)
If you need a mount hole pattern PM me, this was done for a friend and they were not sure of the hole pattern so there isn't one.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
